LatheCity.com
Affordable Hand Wheels for Sherline's Metal Shop

[ Books ]


Tools:
[ Sherline ]
>
[ LASER protractor ]
> [ Mechanical protractor ]

> [ Tailstock ]
> [ Lathe/Mill Stops ]
> [ Monster Vise ]
> [ Endmill Holder ]
> [ Morse taper ]

[ Unimat ]
>
[ Mechanical protractor ]
> [ Tools ]

[ China Lathe ]
[ Vintage ]
[ Craftsman ]
[ HiTorque Bench Lathe
SIEG SC2
]


[ Learning Center ]
[ Product Tests ]
[ Freebies ]


[ How to order ]
[ FAQ ]
[ Customer Feedback ]
[ Customer Corner ]
[ Address
]
[ Contact ]
[ Returns ]
[ US shipping ]
[ International orders ]
[ Privacy ]
[ Site Map ]
[ Disclaimer ]
[ Home ]


[ LatheCity ]
(C) 2012, LatheCity

Affordable Hand Wheels

for Sherline Lathe and Mills


Solution Graphics [ check orders ]

Please read the documentation / manual before ordering.
[ Documentation ]-PDF
[ Documentation ]-HTML
Please read the safety notes before using any accessories:
[ Safety Booklet ]-PDF
[ Safety ]-HTML


PayPal
  • If you want to order more than one item, the shopping cart software is very inflexible in regard of shipping cost calculations. Contact us and we will figure the shipping costs directly. [ Contact ] We have also a few packages set up for you to speed up the process.
  • US standard shipping: single piece $4 (USPS ground, tracking, 4-5 days), packages $6.20 (USPS priority small flat rate boxes, tracking, 2-3 days)
  • International shipping contact us before pushing any buttons. Generally shipping rates are US rates.


Hand wheel pair
$29.99

[ Manual ] - PDF


Scales Selection
PayPal
[ Check orders ]

 

Single hand wheel
$19.99


[ Manual ] - PDF

Scale Selection
PayPal
[ Check orders ]

Why do we offer this?  We recently purchased a Sherline mill table from a none-Sherline vendor (, but apparently genuine Sherline,) since we have had already a milling column at hand. Well, the mill table did fit the budget, but came with little tiny 1.5” or something hand wheels. That’s probably good for a workout; however, it’s not practical in particular on a mill. Looking around: Sherline hand wheels cost $40 the piece. Thus, $80 for hand wheels to upgrade the mill table? Hello, apparently the Sherline stuff can be weight in gold pressed Latinum. Therefore, we came up with a perfectly working but “slighthly” cheaper alternative. The LatheCity hand wheels are made from a 2.5” O.D. steel or brass washer. That washer is connected to an aluminum shaft that fits on Sherline’s mills or lathes and is hold by an auxiliary 10-32 steel setscrew. The slotted disk (not included) for the digital readout (DRO) can be mounted on it, or the wand wheel can be used as is. Since most of us anyhow have a DRO, no sophisticated scale is provided. The hand wheels come with paper glue on scales if required at all.

[ More ... ]

Some of our products are also available from Amazon and e-bay.